1953–2019 Corvette C1–C7 Rust Suffocator – Gloss Finish – Seals and Stops Rust
Quick FAQ
How does Rust Suffocator Gloss Finish compare to POR-15®?
Rust Suffocator contains 77% solids, offering greater coverage and density than POR-15’s 71%. Higher solids contribute to superior rust encapsulation and more UV resistance.
Can Rust Suffocator Gloss Finish be reused?
Yes, but only what hasn’t been exposed to air. Pour unused material through multi-temp reducer over the product in the can before sealing. Do not return thinned or used product to the original container.
Should the surface be prepped before application?
Yes.
-
Remove loose rust and debris with a wire brush.
-
Eliminate grease, oil, or salt residue using a degreaser or solvent.
-
Scuff any painted surfaces to promote adhesion.
-
Ensure surface is dry before application.
Can Rust Suffocator Gloss Finish be applied to bare metal?
Yes.
-
Bare metal must be clean and free of contaminants.
-
For smoother metal surfaces, use a prep treatment like Metal Etch to improve adhesion before applying Rust Suffocator.
Do I need a respirator when I paint?
YES. Always work in a well-ventilated area and use a proper respirator to avoid inhaling harmful vapors.
Can I use lacquer thinner or mineral spirits to thin Rust Suffocator Gloss Finish?
No. These products interfere with the chemistry of the paint. Only use multi-temp reducer or xylene.
What is the proper way to apply the product for best results?
-
Surface must be clean and dry.
-
Stir well before use.
-
Apply using brush, spray gun, or HVLP gun.
-
Apply two thin coats with 3–6 hours drying time between coats.
-
After 48–72 hours cure time, surface can be scuff sanded for topcoat adhesion.
How much coverage does it provide?
Each quart covers approximately 80–100 square feet. Porous or irregular surfaces may reduce coverage.
Can I paint over Rust Suffocator Gloss Finish?
Yes. After 48–72 hours of cure time, scuff the surface to promote adhesion of primers or topcoats.
What happens if Rust Suffocator Gloss Finish is exposed to sun?
Direct sunlight may cause gloss loss over time, leaving a dull black finish. This does not affect protective performance.
Will temperature affect results?
Yes.
How do I clean my equipment after use?
Clean immediately with multi-temp reducer or xylene. Do not allow paint to cure inside the spray gun.
Application / Directions
PREP:
Remove all contaminants from the surface. Use a wire brush to remove loose rust. For bare or sandblasted metal, use Metal Etch before painting. All surfaces must be dry.
Stir Rust Suffocator Gloss Finish gently and thoroughly. Scoop enough material for use in one application. Before sealing, gently pour enough reducer to cover the product in the can.
APPLICATION:
Brushing: Apply unthinned. Lay down an even coat with brush. Allow 3 to 6 hours between coats. Paint can self-level.
Spraying: If needed, thin up to 10% with multi-temp reducer. Use 0.013"–0.017" tip with a pressure of 6–7 PSI for HVLP guns or 25–35 PSI for conventional guns. Spray two medium wet coats, allowing 3 to 6 hours between coats.
Fully cure in 48 to 72 hours.