1977 Dash Wiring Harness Manual Trans 1st Design Alarm in Fender VMA7700MT
1977 Dash Wiring Harness Manual Transmission 1st Design with Alarm located in Fender. Application all manual transmission, 1st design with VIN numbers ending in 02287 to 27372. Alarm switch is located in driver side front fender and alarm horn located behind driver side rear fender.
Distinguishing between 1st and 2nd Design 1977 Corvettes. Shown below is information regarding 1977 (2nd Design) Corvettes as shown in Chevrolet Dealer Service Bulletin 77-I-38, Section XII, Dated May 1977:
Subject: Anti-Theft Alarm System Interim Modifications
Several modifications to the 1977 Corvette anti-theft alarm system were introduced into production effective March 21, 1977 with VIN 1Z37X7S427373.
(2nd Design) modifications are as follows:
- The actuating switch for the alarm system is no longer located on the left (driver's side) front fender. It has been incorporated into the left front door lock and must be activated by locking this door with the key from the outside of the vehicle. This is the *ONLY* way the alarm can be set. Turning the inside knob to the locked position when exiting the vehicle *WILL NOT* activate the alarm system.
- The anti-theft alarm system horn has been moved from the left (driver's side) rear inner fender to the far left side (driver's side) of the engine compartment dash panel.
- The anti-theft alarm system flasher assembly is now located on the console trim plate, rather than the rear compartment underbody panel.
- The new anti-theft alarm system wiring diagram has been modified to reflect these changes.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1977 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1977 Corvette Dash Wiring Harness 1st Design Alarm in LH Fender connects to:
- Air Conditioning Harness Connection (with A/C)
- Alarm System Flasher
- Alarm System Relay
- Brake Light Switch
- Bulkhead Connector (passes through firewall)
- Center Gauge Cluster
- Cigarette Lighter
- Cigarette Lighter Ground
- Courtesy Light (driver & passenger side)
- Courtesy Light Switch (driver & passenger side)
- Courtesy Light Timer Connection
- Courtesy Light Timer Harness Connection
- Fuse Block
- Ground (to hinge pillar inner reinforcement)
- Hazard Flasher (fuse block)
- Headlight Dimmer Switch
- Headlight Switch
- Headlight Warning Buzzer
- Heater & A/C Control Panel Light Harness Connection
- Heater Harness Connection (without A/C)
- Hi-Beam Light
- Horn Relay
- Ignition Switch
- Instrument Cluster Ground
- Instrument Lights
- Neutral Safety Switch Extension Harness Connection
- Parking Brake Warning Light Switch
- Parking Brake Warning Light
- Radio
- Rear Body Harness Connection
- Seat Belt & Key Warning Buzzer
- Seat Belt Buckle Connection (driver side)
- Tachometer
- Turn Signal Flasher
- Turn Signal Light (left & right side)
- Turn Signal Switch Connection
- Windshield Wiper & Washer Switch
Also known under these part numbers: (For reference only)