1975 Engine Wiring Harness without Seatbelt Interlock System Manual Trans
1975 Engine Wiring Manual Trans without Seat Belt Interlock System.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your Corvette left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1975 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1975 Corvette Engine Wiring Manual Trans without Seat Belt Interlock System Connects to:
- Alarm System Anti-Tamper Switch
- Backup Light Switch Connection
- Dash Harness Connection (at firewall)
- Ground (to bell housing bolt)
- Hood Ajar Switch
- Ignition Coil (on distributer)
- Oil Pressure Sending Unit
- Starter Solenoid
- Tachometer Filter Connection
- Windshield Washer Pump
- Windshield Wiper Motor
- Windshield Wiper Motor Ground Terminal
Learn more from the following Mid America Motorworks Knowledge Library article:
Corvette 1974-1975 Seatbelt Starter Interlock System
Also known under these part numbers: (For reference only)