1969 C3 Engine Wiring Harness Big - Small Block Engine Compartment VIG6900
Over time, your 1969 Corvette's Engine Wiring Harness degrades and begins to fall apart. Our complete engine harnesses are a must have for restoration project.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1969 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1969 Corvette Engine Compartment Wring Connects to:
- Air Conditioning Harness Connection (with A/C)
- Dash Harness Connection (at firewall)
- Ground (to starter motor mounting bolt)
- Heater Blower Motor (cars without A/C)
- Heater Blower Motor Ground Terminal (cars without A/C)
- Horn Relay
- Ignition Coil ("+" terminal)
- Starter Solenoid
- Windshield/Headlight Washer Anti-Drip Solenoid
- Windshield Wiper Door Limit Switch Connection
- Windshield Wiper Motor Connection
- Windshield Wiper Motor Ground Terminal
Also known under these part numbers: (For reference only)