1968 Anti-Theft UA6 Alarm System Wiring Harness VAS6800
Ensure that your 1968 Corvette stays safe by replacing your old Alarm System Wiring Harness with a new one.
1968 Corvette UA6 Alarm System Wiring Harness extends to rear center Taillight Panel under the rear emblem lettering.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1968 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1968 Corvette Alarm System Wiring Harness Connects to:
- Alarm System Flasher
- Alarm System Horn Ground (to mounting bolt)
- Alarm System Horn Power Terminal
- Alarm System On/Off Switch
- Alarm System Relay
- Courtesy Light Switch (driver & passenger side)
- Engine Harness Connection
- Fuse Block ("BAT" cavity)
- Ground (to inner door jamb brace, driver side)
- Hood Ajar Switch
- Wiper Motor Ground Terminal
| 1968 |
388 |
26.35 |
| 1969 |
12,436 |
26.35 |
| 1970 |
6,727
|
31.60 |
| 1971 |
8,501
|
31.60 |
Also known under these part numbers: (For reference only)