1964-1965 Engine Wiring Harness with Air Conditioning VIG6465AC
1964-1965 Corvette Engine Wiring Harness with Air Conditioning. This harness includes the A/C wiring and Air Conditioning Compressor Ground Wire.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your Corvette left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1964-1965 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1964-1965 Corvette Engine Wiring Harness with Air Conditioning Connects to:
- Air Conditioning Relay
- Alternator
- Blower Motor
- Blower Motor Ground Terminal
- Blower Motor Resistor
- Blower Motor Speed Switch
- Compressor Clutch Switch
- Compressor Ground
- Dash Harness Connection
- Dash Harness Connection (at firewall)
- Diverter Door Switch (located under dash, on air duct)
- Ground (to A/C mounting bolt)
- Ground (to alternator)
- Ground (to horn relay mounting bolt)(1965 with T.I.)
- Ground (to starter motor mounting bolt)
- Ground (to voltage regulator mounting bolt)(1964 & 1965 without T.I.)
- Horn (driver & passenger side)
- Horn Relay
- Ignition Ballast Resistor (top screw terminal))
- Ignition Coil ("+" terminal)
- Neutral Safety Switch (automatic transmission only)
- Starter Solenoid ("BATT", "S" & "R" terminals.)
- Temperature Sending Unit
- Voltage Regulator
- Windshield Wiper Motor Ground Terminal
Also known under these part numbers: (For reference only)