1963 Engine Wiring Harness without Air Conditioning VIG6300
1963 Corvette Engine Wiring Harness without Air Conditioning.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1963 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1963 Corvette Engine Wiring Harness without Air Conditioning Connects to:
- Alternator
- Dash Harness Connection (at firewall)
- Ground (to starter motor mounting bolt)
- Ground (to voltage regulator)
- Heater Blower Motor
- Heater Blower Motor Ground Terminal
- Horn (driver & passenger side)
- Horn Relay
- Ignition Ballast Resistor (top screw terminal)
- Ignition coil ("+" terminal)
- Neutral Safety Switch/Backup Light Switch Connection (automatic transmission)
- Starter Solenoid
- Temperature Sending Unit
- Voltage Regulator
- Windshield Wiper Motor Ground Terminal
Also known under these part numbers: (For reference only)