1958-1962 Engine Wiring Harness with Manual Transmission VIG5862M
The 1958-1962 Engine Wiring Harness. Application all 1958-1962 Corvettes with manual transmissions.
Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your Corvette left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1958-1962 Corvette.
A commonly asked question and a much needed answer is "What does this harness" connect to?
1958-1962 Corvette Engine Wiring Harness Connects to:
- Ammeter Gauge
- Ignition Ballast Resistor
- Ignition Switch
- Starter Solenoid
- Temperature Gauge (passenger side terminal)
- Temperature Sending Unit
- Voltage Regulator ("Batt" terminal)
Also known under these part numbers: (For reference only)