Call Center Open | 866.350.4540
You are just $99.00 from Free Shipping within the contiguous U.S.
Menu
Categories
Featured Links

1957 Corvette Engine Wiring Harness 2nd Design Automatic without Fuel Injection

  • Photos
product image
Item ID: 697-034
Availability: Out of Stock
Fits Years:
  • 1957
$139.99
subtract
add
  • Description

1957 Engine Wiring Harness 2nd Design Automatic without Fuel Injection

1957 Engine Harness 2nd Design Automatic without  Fuel Injection Wiring Harness.  All 1957 automatic transmission Corvettes built after March 14, 1957 are considered 2nd design for this harness.

Our Original Design Series™ wiring harnesses are manufactured exactly as the wiring was made when your vehicle left the factory in St. Louis. These harnesses are made to the exact O.E.M. (original equipment manufacturer) specifications, using the original factory blueprints, and are factory-correct in every way. These are full-assembled, ready to install, “plug & play” accurate reproduction wiring harnesses. You will NOT have to cut any wires, crimp any terminals, or make any modifications to these harnesses when installing them in your 1957 Corvette.

 

A commonly asked question and a much needed answer is "What does this harness" connect to?

 

1957  Corvette Engine Harness 2nd Design Automatic without  Fuel Injection Wiring Harness Connects to:

  • Ammeter Gauge (passenger side terminal)
  • Automatic Transmission Neutral Safety Relay
  • Ignition Ballast Resistor
  • Ignition Coil ("+" terminal)
  • Ignition Switch
  • Ignition Switch ("BATT" terminal)
  • Starter Solenoid
  • Temperature Gauge (passenger side terminal)
  • Temperature Sending Unit



Also known under these part numbers: (For reference only)

  • A8922
  • VIG5700AL